Publicaciones (77) Publicaciones de FERNANDO ANTONIO CRUZ PERAGÓN

2024

  1. Fast segregation of thermal response functions in short-term for vertical ground heat exchangers

    Applied Thermal Engineering, Vol. 246

2023

  1. Convective drying of mango stone for use as biomass

    Environmental Research, Vol. 227

  2. Prediction of emissions and performance from transient driving cycles using stationary conditions: Study of advanced biofuels under the ETC test

    Case Studies in Thermal Engineering, Vol. 41

2022

  1. Device Modeling for GHE Experimental Test

    Renewable Energy and Power Quality Journal, Vol. 20, pp. 735-739

  2. Energy and exergy analysis during drying in rotary dryers from finite control volumes: Applications to the drying of olive stone

    Applied Thermal Engineering, Vol. 200

  3. Methodology improvements to simulate performance and emissions of engine transient cycles from stationary operating modes: A case study applied to biofuels

    Fuel, Vol. 312

  4. On the spreadsheet in the learning of thermal engines in the undergraduate engineering education: Applications to study turbocharged reciprocating engines

    Computer Applications in Engineering Education, Vol. 30, Núm. 1, pp. 106-116

  5. Optimal design of a hybrid ground source heat pump for an official building with thermal load imbalance and limited space for the ground heat exchanger

    Renewable Energy, Vol. 195, pp. 381-394

  6. Vertical ground heat exchanger parameter characterization through a compound design of experiments

    Renewable Energy, Vol. 199, pp. 1361-1371

2021

  1. Effect of the in-cylinder back pressure on the injection process and fuel flow characteristics in a common-rail diesel injector using gtl fuel

    Energies, Vol. 14, Núm. 2

  2. Experimental studies on mass transfer during convective drying of spent coffee grounds generated in the soluble coffee industry

    Journal of Thermal Analysis and Calorimetry, Vol. 145, Núm. 1, pp. 97-107

  3. Experimental work over borehole filling material to reinforce characterization and model validation of ground heat exchangers

    Renewable Energy and Power Quality Journal, Vol. 19, pp. 109-114

  4. New methodology based on simplifications of the short-term models of CSP for long-term tuning: a case study in Spain

    Case Studies in Thermal Engineering, Vol. 28

2020

  1. Determination of the drying rate and effective diffusivity coefficients during convective drying of two-phase olive mill waste at rotary dryers drying conditions for their application

    Renewable Energy, Vol. 153, pp. 900-910

  2. Economic dispatch of renewable generators and BESS in DC microgrids using second-order cone optimization

    Energies, Vol. 13, Núm. 7

  3. Extending capabilities of Thermal Response Tests in vertical ground heat exchangers: An experiment-based local short-time temperature response factor

    Applied Thermal Engineering, Vol. 178

  4. Parameters sensitivity analysis in a solenoid common-rail injector model

    Renewable Energy and Power Quality Journal, Vol. 18, pp. 250-254

  5. Why we should invest further in the development of internal combustion engines for road applications

    Oil and Gas Science and Technology, Vol. 75, Núm. 1

2018

  1. Methodology to simulate normalized testing cycles for engines and vehicles via design of experiments with low number of runs

    Energy Conversion and Management, Vol. 177, pp. 817-832

  2. New Experimental Rotary Dryer of Olive Stone: Design, Control and Modeling

    Waste and Biomass Valorization, Vol. 9, Núm. 3, pp. 443-449