Publicacions en què col·labora amb FRANCISCO JAVIER TRUJILLO VILCHES (14)

2017

  1. Analysis of the chip geometry in dry machining of aeronautical aluminum alloys

    Applied Sciences (Switzerland), Vol. 7, Núm. 2

  2. Design and implementation of a practical learning methodology for the control and programming of a flexible manufacturing cell

    Materials Science Forum

  3. Experimental methodology design for fatigue behaviour analysis of turned aluminum alloys

    Procedia Manufacturing, Vol. 13, pp. 73-80

  4. Experimental parametric model for indirect adhesion wear measurement in the dry turning of UNS A97075 (Al-Zn) alloy

    Materials, Vol. 10, Núm. 2

  5. Hardening effect analysis by modular upper bound and finite element methods in indentation of aluminum, steel, titanium and superalloys

    Materials, Vol. 10, Núm. 5

  6. Indirect Monitoring Method of Tool Wear using the Analysis of Cutting Force during Dry Machining of Ti Alloys

    Procedia Manufacturing, Vol. 13, pp. 623-630

  7. Indirect adhesion wear parametric analysis in the dry turning of UNS A97075 Alloys

    Procedia Manufacturing, Vol. 13, pp. 418-425

  8. Parametric analysis of the Ultimate Tensile Strength in dry machining of UNS A97075 Alloy

    Procedia Manufacturing, Vol. 13, pp. 81-88

2016

  1. An analysis of geometrical models for evaluating the influence of feed rate on the roughness of dry turned UNS A92050 (Al-Cu-Li) alloy

    Advances in Materials and Processing Technologies, Vol. 2, Núm. 4, pp. 578-589

  2. Design, development and implantation of self-assessment tools in the subject of manufacturing engineering in engineering degrees at the university of malaga

    Materials Science Forum

  3. Mock-up of an eighteenth-century oil mill via rapid-prototyping

    History of Mechanism and Machine Science

  4. Study of the tool geometry influence in indentation for the analysis and validation of the new modular upper bound technique

    Applied Sciences (Switzerland), Vol. 6, Núm. 7, pp. 1-16

  5. Thesaurus and Graphipedia tools development at the manufacturing engineering subjects of the University of Malaga

    Materials Science Forum

2015

  1. Study of the Influence of the Cutting Parameters on the Chip Geometry during Machining Alloy UNS A97075

    Procedia Engineering