Publicacions en què col·labora amb FRANCISCO ANTONIO CORPAS IGLESIAS (14)

2021

  1. Development of cold in-place recycling with bitumen emulsion and biomass bottom ash

    Crystals, Vol. 11, Núm. 4

  2. Development of geopolymers as substitutes for traditional ceramics for bricks with chamotte and biomass bottom ash

    Materials, Vol. 14, Núm. 1, pp. 1-20

  3. Development of high resistance hot mix asphalt with electric arc furnace slag, ladle furnace slag, and cellulose fibers from the papermaking industry

    Applied Sciences (Switzerland), Vol. 11, Núm. 1, pp. 1-23

  4. Evaluation of physical, chemical, and environmental properties of biomass bottom ash for use as a filler in bituminous mixtures

    Sustainability (Switzerland), Vol. 13, Núm. 8

  5. Evaluation of the physical, chemical and environmental properties of ladle furnace slag for their utilization as filler in bituminous mixtures

    Metals, Vol. 11, Núm. 3, pp. 1-15

  6. Study of the incorporation of biomass bottom ash as a filler for discontinuous grading bituminous mixtures with bitumen emulsion

    Applied Sciences (Switzerland), Vol. 11, Núm. 8

2020

  1. Development of porous asphalt with bitumen emulsion, electric arc furnace slag and cellulose fibers for medium traffic roads

    Minerals, Vol. 10, Núm. 10, pp. 1-21

  2. Development of slurry surfacing with electric arc furnace slag for pavements with friction problems

    Minerals, Vol. 10, Núm. 10, pp. 1-19

  3. Evaluation of the use of electric arc furnace slag and ladle furnace slag in stone mastic asphalt mixes with discarded cellulose fibers from the papermaking industry

    Metals, Vol. 10, Núm. 11, pp. 1-23

  4. Retention of contaminants elements from tailings from lead mine washing plants in ceramics for bricks

    Minerals, Vol. 10, Núm. 6, pp. 1-21

  5. Study of the incorporation of biomass bottom ashes in ceramic materials for the manufacture of bricks and evaluation of their leachates

    Materials, Vol. 13, Núm. 9

  6. Study of the incorporation of ladle furnace slag in the manufacture of cold in-place recycling with bitumen emulsion

    Materials, Vol. 13, Núm. 21, pp. 1-20

  7. Surface treatments with dichloromethane to eliminate printing lines on polycarbonate components printed by fused deposition modelling technology

    Materials, Vol. 13, Núm. 12

2017

  1. Corrosion and fracture analysis in screws of dental implants prostheses. New coatings

    Engineering Failure Analysis, Vol. 82, pp. 657-665