INGENIERÍA MECÁNICA Y MINERA

2018

1. 3D mode shapes characterisation using phase-based motion magnification in large structures using stereoscopic DIC

   Mechanical Systems and Signal Processing, Vol. 108, pp. 140-155

2. A more effective rationalisation of fatigue crack growth rate data for various specimen geometries and stress ratios using the CJP model

   International Journal of Fatigue, Vol. 114, pp. 189-197

3. A novel method for the determination of fatty acid esters in aqueous emulsion on Ti6Al4V surface with IRRAS and carbon quantification

   Tribology International, Vol. 128, pp. 155-160

4. A numerical and experimental study of a new Savonius wind rotor adaptation based on product design requirements

   Energy Conversion and Management, Vol. 158, pp. 210-234

5. A simple non-equilibrium bedload transport equation for the formation of dune in a shallowwater flow over an erodible bed

   E3S Web of Conferences

6. Actividad práctica de diseño para la fabricación asistida con CATIA: doblado de chapa metálica

   XXVI Congreso Universitario de Innovación Educativa en las Enseñanzas Técnicas: libro de actas

7. Análisis del ciclo de vida (ACV) de una bomba de calor aire/aire aplicada a un edificio terciario como contribución a una energía renovable

   Revista DYNA, Vol. 93, Núm. 3, pp. 262-268

8. Bar dynamics and sediment transport pulses in gravel-bed channels

   E3S Web of Conferences

9. Best management irrigation practices assessed by a GIS-based decision tool for reducing salinization risks in olive orchards

   Agricultural Water Management, Vol. 202, pp. 33-41

10. Combining the lumped capacitance method and the simplified distributed activation energy model to describe the pyrolysis of thermally small biomass particles

    Energy Conversion and Management, Vol. 175, pp. 164-172

11. Crack tip displacement fields measured by digital image correlation for evaluating variable mode-mixity during fatigue crack growth

    International Journal of Fatigue, Vol. 115, pp. 53-66

12. Crack tip plastic zone evolution during an overload cycle and the contribution of plasticity-induced shielding to crack growth rate changes

    Fatigue and Fracture of Engineering Materials and Structures, Vol. 41, Núm. 10, pp. 2172-2186

13. Damage methodology approach on a composite panel based on a combination of Fringe Projection and 2D Digital Image Correlation

    Mechanical Systems and Signal Processing, Vol. 101, pp. 467-479

14. Detecting fatigue crack closure and crack growth delays after an overload using DIC measurements

    Conference Proceedings of the Society for Experimental Mechanics Series

15. Distinct fracture patterns in construction steels for reinforced concrete under quasistatic loading— A review

    Metals, Vol. 8, Núm. 3

16. Dripping dynamics and transitions at high Bond numbers

    International Journal of Multiphase Flow, Vol. 104, pp. 206-213

17. Effect of in-flight differential pressure in modal behaviour of an aircraft demonstrator using HS 3D-DIC

    Proceedings of ISMA 2018 - International Conference on Noise and Vibration Engineering and USD 2018 - International Conference on Uncertainty in Structural Dynamics

18. Effect of in-flight differential pressure in modal behaviour of an aircraft demonstrator using HS 3D-DIC

    PROCEEDINGS OF INTERNATIONAL CONFERENCE ON NOISE AND VIBRATION ENGINEERING (ISMA2018) / INTERNATIONAL CONFERENCE ON UNCERTAINTY IN STRUCTURAL DYNAMICS (USD2018)

19. Effects of rear cavities on the wake behind an accelerating D-shaped bluff body

    Physics of Fluids, Vol. 30, Núm. 4

20. Energy absorption capacity in natural fiber reinforcement composites structures

    Materials, Vol. 11, Núm. 3