Publications (52) Publications in which a researcher has participated


  1. A blazar as the likely counterpart to 4FGL J0647.7-4418 instead of a gamma-ray binary

    Monthly Notices of the Royal Astronomical Society, pp. 4291-4297

  2. A single-stage megaflood at the termination of the Messinian salinity crisis: Geophysical and modelling evidence from the eastern Mediterranean Basin

    Marine Geology, Vol. 430

  3. An alternative approach for improving DIC by using out-of-plane displacement information

    Optics and Lasers in Engineering, Vol. 128

  4. Analysis of the two-point wheel-rail contact scenario using the knife-edge-equivalent contact constraint method

    Mechanism and Machine Theory, Vol. 148

  5. Application and experimental validation of a multibody model with weakly coupled lateral and vertical dynamics to a scaled railway vehicle

    Sensors (Switzerland), Vol. 20, Núm. 13

  6. Application of the finite element method to the incremental forming of polymer sheets: The thermomechanical coupled model and experimental validations

    Polymers, Vol. 12, Núm. 8

  7. Artificial neural networks applied to the measurement of lateral wheel-rail contact force: A comparison with a harmonic cancellation method

    Mechanism and Machine Theory, Vol. 153

  8. Bending oscillations of a cylinder freely falling in still fluid

    Journal of Fluid Mechanics

  9. Bubble formation regimes in forced co-axial air-water jets

    International Journal of Multiphase Flow, Vol. 128

  10. Bubble pressure requirements to control the bubbling process in forced co-axial air-water jets

    International Journal of Multiphase Flow, Vol. 133

  11. Challenging the “ΔKeff is the driving force for fatigue crack growth” hypothesis

    International Journal of Fatigue, Vol. 136

  12. Comparative of conventional and alternative Digital Image Correlation techniques for 3D modal characterisation

    Measurement: Journal of the International Measurement Confederation, Vol. 151

  13. Comparative study of heat pump system and biomass boiler system to a tertiary building using the Life Cycle Assessment (LCA)

    Renewable Energy, Vol. 152, pp. 1439-1450

  14. Damage identification in frame structures using high-speed digital image correlation and local modal filtration

    Structural Control and Health Monitoring, Vol. 27, Núm. 9

  15. Description of the transitional wake behind a strongly streamwise rotating sphere

    Journal of Fluid Mechanics

  16. Design and analysis of an automatic shell cracking machine of metohuayo (“caryodendron orinocense karst”) with a capacity of 50 kg/h

    Agriculture (Switzerland), Vol. 10, Núm. 11, pp. 1-23

  17. Determination of the drying rate and effective diffusivity coefficients during convective drying of two-phase olive mill waste at rotary dryers drying conditions for their application

    Renewable Energy, Vol. 153, pp. 900-910

  18. Drag reduction of three-dimensional bodies by base blowing with various gas densities

    Physical review. E, Vol. 102, Núm. 1-1, pp. 011101

  19. Drag reduction on a three-dimensional blunt body with different rear cavities under cross-wind conditions

    Journal of Wind Engineering and Industrial Aerodynamics, Vol. 200

  20. Economic dispatch of renewable generators and BESS in DC microgrids using second-order cone optimization

    Energies, Vol. 13, Núm. 7